User's Manual

Table Of Contents

Veri-Series Setup Guide

Mounting Readers On The Wall

1. The readers come disassembled, however, if your reader has previously been

assembled then disassemble the reader body and smart card module (for V-

Smart only) from the wall plate.

a. On V-Smart remove security screw securing smart card module

b. For products other than V-Station, remove security screw securing

the Aux. port cover, and remove the Aux. port cover by twisting (see

graphics on page 25).

c. Remove #4-40 screw securing reader body to wall plate.

d. Remove smart card module (on V-Smart only) and reader body by

sliding up and pulling away from the wall plate.

e. Keep screws and Aux. port cover for re-assembling the device.

2. Define a location. A good location will have these qualities:

a. Comfortable height for finger placement

NOTE:

If readers need to be mounted above

54” or below 48”, please contact Bioscrypt for

available accessories to properly readjust the

angle of the reader for optimal finger

placement. Mounting a reader above or below

the recommended height will not be

ergonomic for the user and will not promote

good finger placement on the sensor.

48” – 54”

b. ADA considerations

c. Provide clearance above and below for

access

d. The access hole in the wall for wiring should be less than 1 ½ inches

wide so that wall plate will cover it. It should be less than 1 ½

inches tall if mounting into dry wall so that there is enough material

to hold the anchor. The recommended size is 1 inch wide by 1

1/8

inches tall to match the opening in the wall plate.

e. For V-Smart, the access hole in the wall for wiring should be less

than 4 ½ inches wide so that wall plate will cover it. It should be