User's Manual

Table Of Contents

Veri-Series Setup Guide

7. Attach pigtail to the reader body

(not applicable to V-Station) and

attach body to wall plate using

same motion as for the smart card

module. Secure the body to the

wall plate with the #4-40 screw at

the bottom. Replace the Aux.

port cover (see next page).

8. The RJ11 security cover is

removed to install the reader

body to the wall mount. Once the screw is in place, the security cover can

be snapped into place using the following procedure:

With the textured side facing down,

1) place left tab into left corner groove on reader body

2) rotate cover until right tab easily slides into groove

3) with tab in the reader body groove, rotate the cover clockwise until the

right tab snaps into place at the right rear corner

Step 1 Step 2 Step 3