User's Manual

Table Of Contents

Veri-Series Setup Guide

Basic Operation

1. Use VeriAdmin software to enroll a new fingerprint:

Enrollment is the process of generating data

that the reader will store and use to later verify

your identity.

a. Make sure that the correct unit is identified on the main toolbar

dropdown.

b. Go to the Template Manager screen.

c. Click on Quick Enroll.

d. Enter an ID number. This can be the number of the user card (prox,

bar code, magnetic stripe, or other technology) or some other

number such as when using the V-Pass or V-Smart.

e. Click on the Enroll button – User must place their finger on the

sensor when the light turns amber and leave their finger on sensor

until the light goes out. Use the RidgeLock during enrollment to

obtain a finger placement consistent with what would be expected

during Verification. The ridge should comfortably fit in the first

crease of the finger. Do not use thumbs for enrollment or

verification.

f. The enrollment will be scored in

terms of Content and Quality on

a scale of 0-5 stars. Bioscrypt

recommends a minimum score of

3 stars for quality and 2 stars for

content. If enrollment scores for

Content and Quality are

acceptable, then click on Accept.

Quality is a measure of how

clearly the fingerprint is shown

in the image.

Content measures how unique

(i.e., curvy) the captured pattern

is.