User's Manual

Table Of Contents

Veri-Series Setup Guide

2. Using the keypad to enroll a new fingerprint (V-Station only):

a. From the idle screen (showing ”Bioscrypt” with the date and time),

press 0-0-0 (three zeroes) and

. You will be warned about no

admin ID.

b. You are now in the V-Station menu system. From here you may

traverse the menus using the

and buttons, the button

to enter a menu, and the

button to back out to the previous

menu.

c. Enter the Template Admin menu, then the Enroll (Add) User menu.

Enter an enroll ID between 1 and 4294967294.

d. Place your finger on the sensor when the amber LED turns on,

making sure to use the RidgeLock.

e. After retrieving the live fingerprint, you will be shown the content

and quality in stars (asterisks) (5 is the best). Bioscrypt

recommends at least 3 stars for quality and 2 for content. To accept

the enrollment, press 1. To reject it, press 2. To re-try enrollment,

press 3.

f. Choose the finger enrolled, 0 - 9 (0 = left pinky, 9 = right pinky).

You may press

if you don’t want to specify a finger.

g. Choose whether the finger should be a Duress finger or not (0 = No,

1 = Yes, or simply

for No).

h. Choose the security level, 0 – 6 (0 = none, 1 = very high, 2 = high,

… 5 = very low, 6 = Password Only). You may press

for the

default (3).

i. Choose the admin level 0 – 2 (0 = user, 1 = enroller, 2 = full admin).

You may press for the default (user).

j. Enter a password for the template, if desired, or

for none.

k. If the unit is a V-Station MIFARE or V-Station iCLASS, the next

menu will ask if you would like to save the template to the unit (1)