User's Manual

Table Of Contents

Veri-Series Setup Guide

or to a smart card (2). If saving to a smart card, you will need to

enter the current site key (it must be numeric, and is set using

VeriAdmin) and then present an appropriate fresh or blank smart

card.

l. Finally, you may elect to enroll an alternate finger with the same ID.

Press 1 for yes or 2 for no

3. Verification is as simple as:

Verification is the process of comparing a live

fingerprint scan to the fingerprint data stored

during enrollment.

a. Present the card to reader (unless using a V-Pass in which case, skip

to b) or enter your ID number at the keypad if using a V-Station

(when in idle mode).

b. When the light turns yellow place the finger on sensor in same

position as when it was enrolled and hold. Use the RidgeLock to

position your fingerprint on the sensor. This will help to generate

consistent finger placement. The ridge should fit comfortably in the

first crease of your finger.

c. When the light turns off, remove the finger and the door lock will

release if the verification was successful (reader will indicate green

for success or red for failure).

4. Cleaning and care of the sensor

The fingerprint sensor is a solid-state device designed to provide years

of trouble-free service. Although there is little to do in terms of

maintenance, a few basics in caring for the sensor will help to ensure a

high level of performance over the life of the sensor.

Oily deposits from your finger accumulate on the surface of the

fingerprint sensor after repeated use. These deposits can degrade the