User's Manual

Table Of Contents

Veri-Series Setup Guide

8. [Ethernet network only]: Typically a star network topology is used with a

network switch or hub, but a bus topology may be used. Be sure to connect

all devices using straight-thru (as apposed to cross-over) cables. The

exception to this is when connecting a single device directly to the

computer Ethernet adaptor.

9. [Ethernet network only]: Up to 254 readers can reside on a single Ethernet

bus, although repeaters may be required to boost the signal over longer

distances. The V-Station supports 10base-T Ethernet (10 Mbps)*. A 10

Mbps Ethernet network supports distances up to 100 meters (328 ft.)

between readers (2,500m with repeaters). Bioscrypt recommends isolating

your network of readers from computers (other than the admin PC) and

other devices to maximize security. A firewall is highly recommended if

the network will include other devices or PCs. For obvious reasons, it is not

a good idea to expose your network of readers to the outside world (i.e., the

Internet).

*Ethernet communication is supported in firmware versions 7.10 and higher.

VeriAdmin 5.10 or higher is required for administration over Ethernet.