User's Manual

Page 34

Appendix A – Installing the R&TTE Installation Kit Filters

The following two sections describe the proper procedures for installing the R&TTE

Installation Kit filters, which are required in certain European countries for full CE

compliance. These kits are required only for the V-Prox and V-Smart products and

are not required for any other Bioscrypt product. More information can be found

regarding the CE R&TTE directive online at the European Union web site:

http://www.europa.eu.int/comm/enterprise/rtte/index.htm

R&TTE Wiring Instructions for the V-Prox, A, H

In order to comply with the conducted emissions requirements of the European

Union (EU) directive EN 55022 for DC power input/output ports, an additional line

filter is needed for installations where power supply cables are greater than 3

meters in length. The required filter is manufactured by JMK Filters (Amhearst, New

Hampshire, USA), Part No. FF-1586-1, and is shipped as part of the installation kit.

Please note the orientation of the filter: the end labeled “LOAD” is to be

connected to the V-Prox device, the end labeled “LINE” is to be connected to

the system power supply.

In order to comply with the radiated emissions requirements of the European

Union R&TTE directive CISPR22, a high-density DB-15 “pass-thru” filter is required.

The required filter is manufactured by Spectrum Control (Fairview, Pennsylvania,

USA), Part No. 56-605-019, and is shipped as part of the installation kit. Please note

that it is necessary to rotate the filter to pass through the aperture of the wall plate

or mullion. It is easiest if the filter is first connected to the pigtail wiring harness

supplied. The cable assembly (and connected filter) is now rotated 90 degrees to

allow passage through the aperture of the wall plate. The V-Prox device should

next be connected to the cable assembly, and then pushed back through the

aperture until the wall plate is between the two mounting flanges of the filter. The

device may now be rotated back 90 degrees to the upright position and lowered

onto the mounting hooks of the wall plate.

Please see figure 16 for wiring details.