User's Manual

Page 35

R&TTE

Wirin

Instru

ction

s for

the

V-

Smart

, A

and

V-

Smart

, A, H

order to comply with the conducted emissions requirements of the European In

order to comply with the conducted emissions requirements of the European

Community directive EN 55022 for DC power input/output ports, an additional line

filter is needed for installations where power supply cables are greater than 3

meters in length. The required filter is manufactured by JMK Filters (Amhearst, New

Hampshire, USA), Part No. FF-1586-1, and is shipped as part of the installation kit.

Please note the orientation of the filter: the end labeled “LOAD” is to be

connected to the V-Smart device, the end labeled “LINE” is to be connected to

the system power supply.

In order to comply with the radiated emissions requirements of the European

Community R&TTE directive CISPR22, a high-density DB-15 “pass-thru” filter is

required. The required filter is manufactured by Spectrum Control (Fairview,

Pennsylvania, USA), Part No. 56-605-019, and is shipped as part of the installation

kit. Please note that it is necessary to rotate the filter to pass through the aperture

of the wall plate or mullion. It is easiest if the filter is first connected to the pigtail

wiring harness supplied. The cable assembly (and connected filter) is now rotated

90 degrees to allow passage through the aperture of the wall plate. The V-Smart

device should next be connected to the cable assembly, and then pushed back

through the aperture until the wall plate is between the two mounting flanges of

the filter. The device may now be rotated back 90 degrees to the upright position

and lowered onto the mounting hooks of the wall plate.

Please see figure 17 for wiring details.