User's Manual

CONNECT READER FOR CONFIGURATION
Part # 430-00186-00 ©Copyright 2007, Bioscrypt Inc.
PIV-Station Installation Guide All rights reserved.
18
Figure 9: Network Configuration dialog
10.2 Check USB COM port.
1. Confirm Reader is connected to power.
2. Connect USB cable to reader then connect it to the PC.
3. The new hardware will be found and Add Hardware Wizard will launch.
4. Select No, not at this time then click Next.
5. Select Search for the best driver in these locations.
6. Uncheck Search removable media.
7. Check Include this location in the search - C:\SiLabs\MCU\CP210x\Win2K_XP.
8. Click Next.
9. This will find the driver and install it.
10. The system will find the new hardware again and Add Hardware Wizard will launch.
11. Follow steps 4 to 8 again.
12. Go to Device Manager and confirm COM port number assigned to Reader.
13. If you can locate either of the drivers below skip to Step 23. If not, skip to step 14.
a. CP210x USB to UART Bridge Controller [in Ports (COM & LPT)].
b. CP210x USB Composite Device [in Universal Serial Bus Controllers].
14. Look at the Other Devices category as an Unknown Device.
15. Double-click on the unknown device.
16. Click on the Driver tab.
17. Click Update driver.
18. The Hardware Update Wizard will appear.
19. Select Install from a list or specific location (Advanced).