User's Manual

USER INTERFACE

14 User Interface

Once the system is installed using the PIV-Station is a simple procedure.

1. On the Contactless model, users simply place their PIV card on the reader.

2. On the Contact reader model, initiate verifications by inserting the PIV card into the reader.

o The unit will prompt for PIN.

o When the screen says Place Finger they may then place their finger.

3. The LCD will then say either “Accepted” (top LED will turn green) or “Rejected” (top LED turns red).

o If accepted, the verification actions specified by the administrator will be executed.

o If rejected, the reader returns to its idle state.

4. When reader returns to idle state, the top LED will turn off.

1.1. Consistent Finger Placement

One key to trouble-free finger-scan recognition is consistent finger placement.

Bioscrypt has designed the Ridge-Lock to create simple user instruction and consistent finger position. The

pictures below show the V-Prox FX but the procedure is the same.

1. Wait for the amber light (LED) to be illuminated.

Figure 15: Amber LED

2. With the fingertip raised rest the tip on the Ridge-Lock at a right angle.

Figure 16: Fingertip on Ridge-Lock

3. Slide the finger across the Ridge-Lock keeping the fingertip raised so as not to touch the sensor.

Figure 17: Slide Finger Across Ridge-Lock

4. Position the finger where the first joint of the finger meets the Ridge-Lock