User's Manual

STEPS IN A COMPREHENSIVE INSTALLATION

4 Steps in a Comprehensive Installation

Every installation is unique. Sometimes the issues are well defined and can be handled in a standard fashion;

sometimes the issues are very specific and may not be immediately recognizable. This document addresses

the issues that may be faced with during a standard installation. The steps for a successful installation are:

• Planning the Installation – Choose the type of hardware required, decide if a network is required, and

the location and number of Readers required.

• Unpack All Items – Unpack all items and cross check against packing list.

• Install Components – Install the cabling and components needed to run system

• Install Software – Install the software needed to set up the Readers.

• Configure ports on the PC – Configure the PC ports to support reader.

• Connect reader for configuration – Connect Reader to USB cable and supply power to unit.

• Mount Readers – Mount the Readers in their final locations.

• Power distribution and reader hook up – Reader wiring via the back panel.

• Power-up Procedure – Check proper power connections and start system safely.

• User interface –Users can begin to use system.

This manual will provide more information on each of these steps in order.

WARNING. PIV-Station readers must be installed by a qualified

technician. If at anytime you do not feel qualified to perform a task,

call Bioscrypt technical support or contact a qualified installer.