User`s manual

6
Fully Setup Driver CD X 1
USB 2.0 Cable X1 (optional)
S/PDIF Cable X 1 (optional)
Rear I/O Panel f or ATX Case X 1
Serial ATA Cable X 1 (optional)
Serial ATA Power Switch Cable X 1 (optional)
How to set up a Jumper?
The illustration shows how to set up jumpers. When a Jumper cap is placed on pins, the
jumper is “close”. If no jumper cap is placed on the pins, the jumper is ”open”. The
illustration shows a 3-pin jumper whose pin1 and 2 are “close” when a jumper cap is
placed on these 2 pins.
Jumper open Jumper close Pin 1-2 close
CPU Installation
Step1: Pull the lever sideway s away from the socket and then raise the lev er up to a
90-degree angle.
Step2: Look f or the white dot/cut edge. The white dot/cut edge should point wards the lev er
piv ot. The CPU will f it only in the correct orientation.
Step3: Hold the CPU down f irmly, and then close the lever to complete the installation.
Step4: Put the CPU Fan on the CPU and buckle it. Connect the CPU fan power cable to
the JCFAN1. This completes the installation.
St e p1 Step2 Step3 Step4