User`s manual

Motherboard Manual
28
Notices:
Not all types of AMD CPU perform above overclock setting ideally; the difference will be based on the
selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under “Overclocking Navigator Engine” item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is “Disabled”; the condition parameter should
be changed to “Enable” to proceed this test.
BIOS SETUP U TILITY
Main Advanced
PCIPnP B oot
Chipset T-Series
vxx.xx (C)Cop yright 1985-200x, American Megatrends, Inc.
Select Screen
Select Item
Change Option
General He lp
Save and E xit
Exit
+-
F1
F10
ESC
T-Series Se ttings
=========== Autom ate OverClock System ===========
=========== = Manu al OverClock System ============
Notice: Ple ase Cl ear CMOS if system no display
aft er ove rclocking.
OverClock N avigat or [Normal]
> G.P.U Pha se Con trol
Auto OverCl ock Sy stem [V6-Tech Engine]
CPU/HT Referen ce Clock (MH z) [200]
CPU Configu ration [Auto]
> CPU Tunin g
> Clock Con trol
> Voltage C onfigu ration
> DRAM Timing Con figura tion
> Memory Co nfigur ation
Integrated Memory Test [Disabled]
Exit
Option s
Enabled
Disabled
↓
BIOS SETUP U TILITY
Main Advanced
PCIPnP B oot
Chipset T-Series
vxx.xx (C)Cop yright 1985-200x, American Megatrends, Inc.
Select Screen
Select Item
Change Option
General He lp
Save and E xit
Exit
+-
F1
F10
ESC
T-Series Se ttings
=========== Autom ate OverClock System ===========
=========== = Manu al OverClock System ============
Notice: Ple ase Cl ear CMOS if system no display
aft er ove rclocking.
OverClock N avigat or [Normal]
> G.P.U Pha se Con trol
Auto OverCl ock Sy stem [V6-Tech Engine]
CPU/HT Referen ce Clock (MH z) [200]
CPU Configu ration [Auto]
> CPU Tunin g
> Clock Con trol
> Voltage C onfigu ration
> DRAM Timing Con figura tion
> Memory Co nfigur ation
Integrated Memory Test [Enabled]
Exit
Option s
Enabled
Disabled
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from “Enable” to “Disable”
to complete the test.