Technical Manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Safety during Use
- 3 Getting Started
- Device Overview
- Symbols on the Device
- BIOwand Status Indicator (LED)
- Power Adapter On/Off Light Indicator (LED)
- Bluetooth Status Indicator (LED)
- Telemetry Status Indicator on the Programming Head
- Setting up the Device
- Connecting the Programming Head (BIOwand PGH)
- Connecting the Power Adapter and Switching on the Device
- Establishing a Connection to the BIOwand App
- Establishing a Connection to a stimulator
- Error Resolution
- 4 Appendix
Getting Started
BIOwand Status Indicator (LED)
11
BIOwand Status Indicator (LED)
The BIOwand status indicator shows the following device statuses:
LED behavior and color Device status
LED does not indicate any behavior No power received (disabled)
LED flashes green Device performing self-test
LED lights up green continuously Ready for use
LED lights up orange continuously Device is not ready for use (an error has
occurred, see Error Resolution [Page14])
Power Adapter On/Off Light Indicator (LED)
The on/off light indicator of the power adapter shows the following statuses:
LED behavior and color Device status
LED does not indicate any behavior Disabled
LED lights up green continuously Ready for use
Bluetooth Status Indicator (LED)
The status indicator for pairing/disconnecting the Bluetooth connection shows the following device
statuses:
LED behavior and color Device status
LED does not indicate any behavior There is no Bluetooth connection
LED flashes blue A Bluetooth connection to the device is being
established (pairing)
LED lights up blue continuously There is a Bluetooth connection
Telemetry Status Indicator on the Programming Head
The indicator for the telemetry status is a ring LED directly on the programming head. The ring LED
indicates the following status of the telemetry contact:
Ring LED behavior Telemetry status
Ring LED does not indicate any
behavior
There is no telemetry contact between the programming head
and a stimulator.
Flashing green There is telemetry contact between the programming head and a
stimulator.
Flashing red The connection to the stimulator is disturbed due to electromag-
netic interferences.