Technical Manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Safety during Use
- 3 Getting Started
- Device Overview
- Symbols on the Device
- BIOwand Status Indicator (LED)
- Power Adapter On/Off Light Indicator (LED)
- Bluetooth Status Indicator (LED)
- Telemetry Status Indicator on the Programming Head
- Setting up the Device
- Connecting the Programming Head (BIOwand PGH)
- Connecting the Power Adapter and Switching on the Device
- Establishing a Connection to the BIOwand App
- Establishing a Connection to a stimulator
- Error Resolution
- 4 Appendix
Appendix
Country-related information
16
Power adapter (FW8000M/12)
Category Design
Supply voltage 100–240V, ±10%/ 50–60Hz, 0.3–0.15A/AC
Protection class II
Maximum power input 12W
Level of efficiency ≥ 82.95% (at 115V/60Hz and 230V/50Hz)
On/off light indicator Green LED, lighted continuously
Bluetooth
Category Design
Frequency band 2.4GHz ISMBand
Operating frequency 2400–2483.5MHz
Number of channels 40
Frequency range 2 MHz per channel
Maximum power of transmission (EIRP) Class2: 4dBm (2.5mW)
Modulation GFSK, DQPSK, 8DPSK
Standard BLE5.0
Accessories
BIOwand is only available as a complete system (device, power adapter, and programming head).
Country-related information
International radio certification
Telemetry information for Australia:
This device is in compliance with the Australian "Radiocommunications Act 1992" and, therefore, it
is labeled according to the "Radiocommunications (Compliance labeling – Devices) Notice".
Telemetry information for the USA:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.