User Manual

26 Using Basic Functions
Using Basic Functions
External Printer
You can connect an external printer to the
programmer under the following electrical safety
conditions:
With the exception of the wireless connection, after
the system has been installed in the hospital,
compliance with the leakage current limit values
according to EN 60601-1-1, Paragraph 19 must be
demonstrated.
The following devices can be configured:
• The printer is connected via a wireless connection;
see „Bluetooth interface“ on page 22.
• The printer is battery-operated and is connected to
the USB port of the ICS 3000 Docking Station.
• The printer is powered via the mains supply and is
connected to the USB port of the ICS 3000 via an
isolating separator (EN 60601-1-1, Paragraph 17.201)
with a dielectric strength of at least 1.5 kV (e.g. an
isolating USB-hub model UISOHUB4 by B&B
electronics).
• The printer is supplied directly from the mains by a
medical device power pack and connected to the USB
port of the ICS 3000.
Note: The printer must be set up outside the patient's
vicinity (at least 1.5 meters away from the patient).
Any printer that supports the PCL5 printer language
and is compatible with a generic HP driver can be
used.