Warranty

BioWaveGO User’s Manual
BioWave Corporation12
2.2 Device Controls
Power Button
The Power Button is located on the top of the stimulator. Pressing the Power Button
turns the stimulator on. While the stimulator is on, pressing the Power Button once
immediately pauses the treatment (intensity is reduced to zero and the countdown
timer pauses). Holding the Power Button down for 2 seconds turns the stimulator off.
Power should be turned on after the Pain Relief Pads are attached to your body and to
the cable, and the cable is plugged into the stimulator.
PLUS Button (+)
Pressing the PLUS (+) Button starts the treatment and increases the intensity of the
signal and the level of the tingling/pressure sensation that you feel.
MINUS Button (
–
)
Pressing the MINUS (
–
) Button decreases the intensity of the signal and the level of the
tingling/pressure sensation that you feel.
2.3 Controls via the App Using Bluetooth
(Recommended)
Using the BioWaveGO App will greatly enhance your BioWave experience. You
can start, stop and adjust the intensity of your treatment using the app. You can
also track your pain relief progress over time. The treatment can also be controlled
simultaneously directly from the PLUS/MINUS button on the device.