Warranty

BioWave Corporation 83
For example if the cable was accidentally unplugged, plugging the cable back
in would correct the problem, the LED bar graph will change to show remaining
treatment time in WHITE. You then have to manually ramp up the intensity from zero
back to the prior treatment level to continue the treatment.
LEADWIRE CABLE CONNECTION TO THE DEVICE
Make sure the leadwire cable is plugged all the way into the device.
PAIN RELIEF PAD CONNECTION TO THE LEADWIRE CABLE
Make sure the blue connector on each of the two Pain Relief Pads is each plugged into
each of the two blue connectors on the leadwire cable.
If an Pain Relief Pad connector has detached from the cable connector mid treatment,
replug the Pain Relief Pad back into the leadwire cable to establish a positive electrical
connection. The 5 LEDs will stop blinking ORANGE and the LED bar graph will
change to show remaining treatment time in WHITE. You then have to manually ramp
up the intensity from zero back to the prior treatment level to continue the treatment.
PAIN RELIEF PAD CONNECTION TO THE PATIENT
If the stimulator, cables and Pain Relief Pads are all properly connected to each other
and to the patient’s body yet the 5 LEDs are still blinking ORANGE, then there are four
conditions to check that can cause this error to occur:
8. Troubleshooting