Quick Reference Guide There are 3 buttons that control the device: 1 1. Power ON/OFF button 2 2. PLUS (+) button to increase intensity 3 3. MINUS (–) button to decrease intensity NOTE: Turn on device AFTER you have completed the set up steps on the next page.
Directions for Use Do not turn on unit until Step 6. 1. Plug in the AC charger into your BioWaveGO unit to charge up the battery. (Takes about 1 hour.) 2. Find your PAD PLACEMENT PHOTO for your specific pain site on pages 6-10 of this Quick Reference Guide 3. Plug blue Pad CONNECTORS into blue LEADWIRE CABLE CONNECTORS. 4. Clean your skin with a damp washcloth in the location the PADS are placed. Apply Pain Relief Pads directly over areas of pain. 5.
LED Bar Graph Indicator The LED bar graph provides treatment information in different colors:
Using the Device Mobile App Control Alternative Treatment Tips • Make sure pads are tacky and placed correctly on the body based on the Pad Placement Photos on pages 6-10 of this Guide or at BioWave.com/start • Users should increase intensity to a level that is strong but still comfortable by pressing the PLUS (+) button BioWaveGO can be used with or without the App • First make sure you are connected to the BioWaveGO device and you have completed steps 1-6 or 1-7 on page 2.
Troubleshooting My BioWaveGO is turned on and all it does is beep and the lights blink ORANGE. Answer: The device does not see a complete connection to your skin. Therefore, please make sure of the following: 1. The leadwire cable is firmly plugged into the BioWaveGO unit. 2. Both pads are plugged into the other ends of the lead wire cable. 3. Your skin has been thoroughly cleaned with a damp towel. 4. The pads are tacky and have good adhesion to your skin.
Refer to biowave.com/start for more information on Pad Placement BioWaveGO pad placements are different from TENS and other conventional electrical stimulation. The BioWave active electrical field forms beneath and surrounding each pad. As a result, pads need to be placed directly over specific locations of pain. 1. TWO LOCATIONS OF PAIN – each pad should be placed directly over a painful area. 2.
Pads Must Never Touch Each Other
Pads Must Never Touch Each Other Calf Pain - One Pad Over Pain Site (e.g. Gastrocnemius Strain) Other Pad is Placed Toward Bottom of Knee Cap Shin Pain (e.g.
Pads Must Never Touch Each Other Ankle or Foot Pain on Outside of Foot (e.g.
Pads Must Never Touch Each Other
Contraindications – When Not to Use BioWaveGO • Do NOT place pads over the heart, on the front or side of the neck, or on top of the head. • Do NOT place pads over open wounds, broken skin, rashy skin or sensitive areas like suburned skin. • Do NOT use BioWaveGO if you have an implanted cadiac pacemaker. NOTE: BioWaveGO MAY BE USED over any location on the body that contains implanted metal hardware including total joint replacements, rods, plates, screws, anchors or pins.
Need help? Reordering pads? Contact us at: biowave.com/reorderGOPADS • painfree@biowave.com 1-877-BIOWAVE x1 • (1-877-246-9283, x1) biowave.