Assembly Instructions
E
Components and Hardware List
G
Ø5/16-18 x 2"
Allen Head Bolt
5/16" Flat Washer
5/16" Spring Washer
5mm Allen Wrench
12 pcs.
12 pcs.
1 pc.
Made in China
Page 1 of 1
12 pcs.
H
A
B
C
1 pc.
2 pcs.
Table Top
D
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment. To prevent scratches o r damage, assemble the table on a soft surface such as a
blanket or carpet.
Table Top Leaf
ASSEMBLY STEPS:
1. Carefully place the Table Top upside down on a clean, soft surface.
2. Attach three Legs (D) into the corners of the Table Top (A) as shown, using the 2" Allen Head Bolts
(E), Spring Washers (F) and Flat Washers (G). Do not fully tighten Bolts until Step 5.
3. Position a Shelf (C) into the notches of the three Legs attached and attach using the same Bolts and
Washers as in previous step. Do not fully tighten Bolts. Repeat for other Shelf.
4. Position and attach the fourth Leg using the same Bolts and
Washers as in previous steps.
5. Adjust parts if necessary and tighten all Bolts using the Allen
Wrench (H).
6. Using two people, carefully set the assembled Table upright.
7. To install the Leaf, reach underneath the Table Top and
unlock the two top Latches. Using two people, pull both
halves of the Table Top fully open. Position the Leaf between
the top halves, aligning the pins with the holes on the edge of
the Table Top and Leaf. Push both halves of the Table Top
back together, reach underneath the Table Top and re-lock
the Latches.
4 pcs.
F
1 pc.
Shelf
Leg
STEP 1, 2
STEP 3, 4, 5
STEP 6
D
H
E
F
G
E
F
H
G
E
F
H
G
D
A
TABLE LOCK
Open position
TABLE LOCK
Closed position
C
B
HEIGHT DINING TABLE
Dining Room
Assembly Instructions