Assembly and Installation Instructions

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
Turn off the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List:
A: 11"
B: 14"
C: 29”
A
C
B
C
1. Pull out the wires and grounding wire from the post.
Make wire connections using the wire nuts:
---The hot wire (usually balck insulation) from the
fixture to the black wire from the post.
---The neutral wire (usually white insulation) from
the fixture to the white wire from the post.
---The grounding wire (usually green insulation or
bare wire from the fixture to the grounding wire
from the post.
Carefully put the wires back into the post.
2. Place the fitter on the top of the post, and then secure it with
fitter screws.
NOTE: With silicone caulking compound, caulk completely around
where the fitter meets with the post surface to prevent water from seeping into the post.
3. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Bulb Type A Max.100W
(not included)
Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter Screw(A)
Fitter
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Fitter Screw (A)
Wire Nut (B)
Turn off the power at fuse or circuit box
Installation Steps
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Fitter Screw (A)
Wire Nut (B)
Turn on the power at fuse or circuit box
Photocell
Assembly Kit
(1SET)