Installation & Assembly

ManualsBrandsBirch Lane ManualsBar FurnitureOzan Counter & Bar Stool

530C2-29 PANEL BACK 29"H BAR HEIGHT CHAIR

ASSEMBLY INSTRUCTION

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly,

place the

contents on a carpeted or padded area to protect

them from damage.

Chair Back

1pc

Box Frame

1pc

Wooden Seat

1pc

Front Leg (Left-Right)

2pcs

Side Stretcher (Long)

Front Stretcher (Short)

2pcs 1pc

Jcbc Bolt

M6 x 70mm

Lock Washer

Flat Washer

Jcbc Bolt

M6 x 40mm

8pcs 2pcs

10pcs

Csk-Cb Screw

#8 x 1"

Allen Key

M4 x 60mm

6pcs

10pcs

Pan Head Screw

#8 x 1 1/2"

Glue

1pc 1pc

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTION 530C2-29 PANEL BACK 29"H BAR HEIGHT CHAIR Chair Back Box Frame Wooden Seat Front Leg (Left-Right) 1pc Side Stretcher (Long) 1pc Front Stretcher (Short) 1pc Jcbc Bolt M6 x 70mm 2pcs Jcbc Bolt M6 x 40mm 2pcs 1pc 8pcs 2pcs Lock Washer M6 Flat Washer M6 Csk-Cb Screw #8 x 1" Pan Head Screw #8 x 1 1/2" 10pcs 10pcs 6pcs 6pcs Allen Key M4 x 60mm Glue 1pc 1pc This page lists all the contents included in the box.
PAGE 2
Put the Chair Back (A), Box Frame (B) upside down on the soft and smooth surface.With assistance attach Box Frame (B) onto Chair Back (A). Then insert Jcbc Bolt (G), Lock Washer (I) and Flat Washer (J) into predrilled holes of each corner by using Allen Key (M). Insert Jcbc Bolt (H), Lock Washer (I) and Flat Washer (J) into the pre-drilled holes of the middle of Chair Back (A) by using Allen Key (M). Do not fully tighten the bolts in this step.
PAGE 3
Attach Front Leg (D) assembly to corner of Box Frame (B) along inserting the Front Stretcher (F) onto each hole on Front Leg (D) with applying some Glue (N), then insert Jcbc Bolt (G), Lock Washer (I) and Flat Washer (J) using Allen Key (M). Insert Pan Head Screw (L) into the holes of Front Leg (D) and Stretcher (F) by using screwdriver (not included).
PAGE 4
Attach Wooden Seat (C) and Box Frame (B) with Csk-Cb Screw (K) by using screwdriver (not included). Tighten all screws in this step. Turn the assembled chair to the upright position carefully. Make sure the chair is level, and then securely tighten all bolts at this stage. Assembly is now completed. Stand chair up on an even surface and check that it is balanced. If there is a slight wobble, apply downward pressure in the corner where a leg is uneven. Keeping pressure in that corner, tighten all bolts.