User's Manual

34
19.3 Detection
Red LED
Comes on
–
Comes on
Detection by presence detector, output switched
Detection by motion detector, output switched
Detection by presence and motion detector, both outputs switched
Display
Procedure / description
Green LED
–
Comes on
Comes on
19.1 Switching ON and initialising
Overview function indications
The green LED is not relevant during switch-on and initialisation and there is no need to take account of it. It is absolutely essential that
no-one enters the sensor fields during the entire initialisation procedure. Refer to chapter 3 for more information.
1. Slow flashing for 8 seconds
2. Fast flashing for 4 seconds
3a. Goes out or
3b. Comes on
Device is connected to electrical supply and background teach-in procedure is in progress
Device is initialised and ready, no detection
Device is initialised and ready, with detection í Remedy: Manual teach-in of the
background with A + 3 (chapter 10.4)
Red LED display
Procedure / description
19.2 Programming with remote control
Red LED
–
Flashes 1x
Programming a level in accordance with prEN12650 / DIN 18650 and AutSchR (FRW / escape
and rescue route systems)
Programming a level not in accordance with prEN 12650 / DIN 18650 or AutSchR. This
simultaneous flashing of green and red continues for as long as settings are programmed
on the device that are not in accordance with prEN 12650 / DIN 18650 or AutSchR.
Display
Procedure / description
Green LED
Flashes 1x
Flashes 1x
19
LED displays