User's Manual

40
Bircher Reglomat AG, Wiesengasse 20, CH-8222 Beringen, Phone [phone], Fax [phone]
Overview countries
X = Jupiter and Jupiter SE are applicable in these countries:
Switzerland Austria Germany The Netherlands Belgium Luxembourg
France Italy Spain Portugal United Kingdom Ireland
Denmark Finland Sweden Norway Greece
1. The warranty and liability of Bircher Reglomat AG are
based on the sales contract.
2. The warranty and liability shall expire prematurely, should
the client or third parties not use and/or operate the prod-
uct in compliance with existing operating instructions,
should incorrect changes or repairs be made by the client
or third parties, should the client or third parties, when
a fault has occurred, not take suitable steps at once for
a reduction of possible damage/losses and offer Bircher
Reglomat AG a chance for remedying the said fault.
3. The warranty and liability shall exclude any damage for
which there is no proof that it is due to poor materials,
faulty construction, poor workmanship, and any damage
caused by other reasons, for which Bircher Reglomat AG
cannot be held liable.
4. No liability can be assumed for any consequential dam-
age, provided this is not governed otherwise by applica-
ble product liability laws and regulations.
5. Warranty claims made against the seller on the basis of
the sales agreement are not affected by these regula-
tions.
6. For the benefit of its customers Bircher Reglomat AG
constantly develops its products further. Bircher Reglo-
mat AG reserves the right to make changes to any of the
products described in this document without prior notice.
Warranty and Liability
FCC-Approval
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications made to this equipment not expressly approved by Bircher
Reglomat AG may void the FCC authorization to operate this equipment.
EC Declaration of Conformity
Bircher Reglomat AG herewith declares the products Jupiter and Jupiter SE to be in conformance
with the basic requirements and other relevant regulations as contained in the 1999/5/EC directive.
The full version of the Declaration of Conformity can be viewed on our internet homepage:
www.bircher-reglomat.com