Operation Manual

DAS Software Configuration
92
FOR Fiber Network Settings
This page allows for manual override of network settings. Default configurations should be used with DHCP set to
Yes.
Note: Changing DHCP to “No” can cause loss of communications to the BIU and should only be used in
very specific situations. Do not enter IP configuration data in other associated settings.
Figure 101 FOR Network Settings
1
2
ITem Description
1
Subcarrier Tx Power is used for the communications and control signaling of
the DAS. Default setting is -10. The value may need to be changed in
situations where fiber loss is near the maximum and communications issues
arise. Unnecessarily increasing the subcarrier TX power may affect RF
performance of the DAS.
2 Default seeing of Yes should be used except for special applications.
Figure 102 More FOR Network Settings