Operation Manual
Table Of Contents
- Safety Precautions
- About This Manual
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 System Description
- Chapter 3 Installation guidelines
- Chapter 4 DAS Software Configuration
- Chapter 5 Commissioning
- Chapter 6 RF Commissioning
- Chapter 7 Troubleshooting
- Alarms
- Base Station Gateway (BGW) Alarms
- Fiber Optic Remote (FOR) Alarms
- Remote Unit (RU) Alarms
- Fiber optic Interface (FOI) Alarms
- Base Station Interface (BIU) Alarms
- Medium Power Amplifier (PA) Alarms
- Variable Gain Amplifier (VGA) Alarms
- Analog Pre-distortion (APD) Amplifier Alarms
- Multi-carrier Power Amplifier Interface (MPI) alarms
- Alarms
- Chapter 8 Model Identification
Fiber Distributed Antenna System (Fiber DAS)
61
Solar Shield
Direct exposure to sun light can cause temperatures of the repeater to exceed the 55 °C (131°F) rating. A simple
solution offered by Bird is to attach an optional solar shield to the affected repeaters. The solar shields are sold
separately.
Figure 53 Remote Unit Solar Shield
Cabling
There are many options for the Bird repeaters which can affect the number of connections on the bottom of each
repeater. The standard connections are:
Ethernet port
RF Ports (N-Type standard)
Input Power
External alarm port
Grounding
Fiber Optic (optional)
Figure 54 Repeater Cabling Connectors
Fiber-Optic
Ports (Optional)
Ethernet
Port
Chassis
Ground
External Alarms
Connector
Input Power
Connector
Chassis
Breather
Port
Service Antenna
Connector
Donor Antenna
Connector
LED Indicators










