Operation Manual
Table Of Contents
- Safety Precautions
- About This Manual
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 System Description
- Chapter 3 Installation guidelines
- Chapter 4 DAS Software Configuration
- Chapter 5 Commissioning
- Chapter 6 RF Commissioning
- Chapter 7 Troubleshooting
- Alarms
- Base Station Gateway (BGW) Alarms
- Fiber Optic Remote (FOR) Alarms
- Remote Unit (RU) Alarms
- Fiber optic Interface (FOI) Alarms
- Base Station Interface (BIU) Alarms
- Medium Power Amplifier (PA) Alarms
- Variable Gain Amplifier (VGA) Alarms
- Analog Pre-distortion (APD) Amplifier Alarms
- Multi-carrier Power Amplifier Interface (MPI) alarms
- Alarms
- Chapter 8 Model Identification
DAS Software Configuration
76
BIU Advanced Network Setup
This page allows for manual override of network settings.
Default configurations should be used with DHCP set to Yes.
Note: Changing DHCP to “No” can cause loss of communications to the BIU and
should only be used in
very specific situations.
Figure 75 BIU Network Setup
BIU Advanced Menus
These menus provide information only status and settings of the BIU that are typically used by the manufacturer.
BIU > Advanced>HW config
BIU > Advanced>AD-values RF1
BIU > Advanced>AD-values RF2
BIU > Advanced>ADC raw
BIU > Advanced>Software status
BIU > Advanced>Process status
BIU > Advanced>System status