User's Manual
Table Of Contents
- 1 Introduction
- 2 DMR Operational Description
- 3 DMR Specifications
- 4 Installation guidelines
- 4.1 RF Exposure
- 4.2 Health and Safety
- 4.2 Health and Safety
- Read all available documentation and warnings before handling the equipment! Equipment failures due to improper handling are normally not covered by the product warranty!
- Keep passwords and other operational information away from unauthorized personnel!
- Bird Repeater system is an advanced technology system and should be handled by FCC Licensee or FCC approved staff.
- Read all documentation and warnings before handling the equipment.
- Obey all warning signs on the equipment and in documentation.
- The equipment may get hot during operation, do not operate outside permitted temperature range and keep away from heat sensitive material!
- The equipment contains ESD sensitive components. Open the equipment ONLY in a safe location designed for handling ESD products and use grounding devices! Opening the unit is not intended for field maintenance!
- The equipment contains ESD sensitive components. If not handled with care critical components may be damaged or destroyed. To avoid any damage due to ESD standard ESD precautions shall be used when handling the equipment.
- The product transmits RF signals keep away from Antennas and other radiating devices.
- Repeaters generate radio signals which are transmitted by the connected antennas. Installations should always be done so that the radiation exposure doesn’t exceed the recommendation set up by local authorities.
- Consult a FCC licensee or other applicable regulation body for details on RF requirements and safety issues on RF!
- Electrical installation shall be done in accordance with local safety regulations and laws.
- Make sure to use the equipment only in its intended applications and on the allowed frequencies.
- Avoid overheating by avoiding sunlight exposure!
- 4.2.1 Installing the DMR Repeater Unit
- 4.2.2 Antenna Connections
- 4.2.3 Power AC
- 5 DMR Repeater Commissioning
BIRD DMR USER MANUAL
9
Revision 2
5 DMR Repeater Commissioning
After the successful mounting installation and powering of the DMR Repeater, user can now start
commissioning the Repeater unit.
Accessing the DMR Repeater units is through the Remote Station Gateway (RGW).
Login and access information such as username and passwords are provided separately by Bird
application engineers.
5.1 Commissioning using Remote Gateway
(RGW)
Bird DMR Repeater units are equipped with an RGW. The RGW is basically a PC/server used for
handling multiple units, alarm management, remote access, commissioning and configurations.
Follow the steps below to set up the repeater network. RGW uses a secure protocol and its IP is by
factory default set to use 192.168.0.2 IP address.
After configuring the PC to use the static IP, open the Web browser and enter the following:
https://192.168.0.2
Log into the RGW with the username and password provided by Bird application engineering.
When logged in, navigate to the configuration menu and put the managed repeater unit into the
DNS of the RGW. See pictures below for reference.