User's Manual
Table Of Contents
- 1 Introduction
- 2 DMR Operational Description
- 3 DMR Specifications
- 4 Installation guidelines
- 4.1 RF Exposure
- 4.2 Health and Safety
- 4.2 Health and Safety
- Read all available documentation and warnings before handling the equipment! Equipment failures due to improper handling are normally not covered by the product warranty!
- Keep passwords and other operational information away from unauthorized personnel!
- Bird Repeater system is an advanced technology system and should be handled by FCC Licensee or FCC approved staff.
- Read all documentation and warnings before handling the equipment.
- Obey all warning signs on the equipment and in documentation.
- The equipment may get hot during operation, do not operate outside permitted temperature range and keep away from heat sensitive material!
- The equipment contains ESD sensitive components. Open the equipment ONLY in a safe location designed for handling ESD products and use grounding devices! Opening the unit is not intended for field maintenance!
- The equipment contains ESD sensitive components. If not handled with care critical components may be damaged or destroyed. To avoid any damage due to ESD standard ESD precautions shall be used when handling the equipment.
- The product transmits RF signals keep away from Antennas and other radiating devices.
- Repeaters generate radio signals which are transmitted by the connected antennas. Installations should always be done so that the radiation exposure doesn’t exceed the recommendation set up by local authorities.
- Consult a FCC licensee or other applicable regulation body for details on RF requirements and safety issues on RF!
- Electrical installation shall be done in accordance with local safety regulations and laws.
- Make sure to use the equipment only in its intended applications and on the allowed frequencies.
- Avoid overheating by avoiding sunlight exposure!
- 4.2.1 Installing the DMR Repeater Unit
- 4.2.2 Antenna Connections
- 4.2.3 Power AC
- 5 DMR Repeater Commissioning
BIRD DMR USER MANUAL
19
Revision 2
5.2.9 Communication
The Communication menu contains a number of settings, giving the user the ability to define the
communications with the repeater. Ethernet IP addresses, MAC ID are displayed.
User has three options for the IP configuration settings.
• Static- IP address that is manually defined by the user.
• Default- IP address is set to the factory default address, 192.168.0.202
• Automatic. IP address is provided by a DHCP server. This option is used only when the
Remote Gateway (RGW) is optionally used in the actual repeater.
User has a possibility to change the hostname and the Unit ID of the repeater. Unit ID is the name of
the repeater seen in the web interface.
This change must be manually set which follows by a reboot command for the change to take place.