INSTRUCTION SHEET RF DIRECTIONAL THRULINE® POWER SENSOR MODEL 5010 ©Copyright 2003 by Bird Electronic Corporation Instruction Book Part Number 920-5010 Rev.
Connecting Sensor CAUTION Do not connect or disconnect sensor interface cable to the DPS while the DPM or SA is on. Always turn off the power meter before connecting or disconnecting a sensor. Although unlikely, it is possible to corrupt the firmware in the power sensor (DPS) by connecting it to a power meter, such as the Bird Model 5000 (DPM) or a Bird Site Analyzer (SA), while the power meter is turned on.
Element Contact Alignment With continuous insertion or rotation of the element sensor, the element contact spring may change position slightly within the element socket. In some cases, this change of position may result in intermittent contact with the element giving erratic power readings. The position of the contact spring may be adjusted with a small screwdriver in order to reestablish contact. CAUTION If the element stops short of full insertion, do not force the element into the socket.
2. After centering the contact, bend the contact bar slightly toward the center of the element socket bore, so that the profile of the element contact is visible when viewing the element socket from the top of the socket bore. 3. If the contact is accidently moved too far, the element will not slide into the socket. Move the contact back into the recessed area and repeat the process.
Physical and Environmental Specifications General: Thruline two-element line section Operating Temperature: 0 to 50 °C Storage Temperature: –40 to 75 °C Mechanical Shock: In accordance with MIL-T-28800D Class 3 Vibration: In accordance with MIL-T-28800D Class 3 Humidity: 95% ± 5% maximum (non-condensing) EMC: Complies with directive 89/336/EEC with exceptions noted. Emissions, EN55011 Immunity, EN-50082-2 at 10 V/m. Safety: Complies with EN-61010-1:1993 with amendment # 2: 1995.
® Model 5010 Directional Power Sensor Input Output Interface Bird Electronic Corp. Solon, Ohio USA 5” (130 mm) 3.5” (90 mm) Reflected Forward Output Input Output 2.
DECLARATION OF CONFORMITY Manufacturer: Bird Electronic Corporation 30303 Aurora Road Cleveland, Ohio 44139-2794 Product: Models: Digital Power Meter and Power Sensor 5000 5010 The undersigned hereby declares, on behalf of Bird Electronic Corporation of Cleveland, Ohio, that the above-referenced product, to which this declaration relates, is in conformity with the provisions of the following standards: • European Standard EN 55011:1991 - Emissions: Class B • European Standard EN 61000-3-2:1995 - Emis