Keyfree RF manual Ver. 2.1 Keyfree RF is a digital card key capable of locking and unlocking car doors conveniently. www.bisro.co.kr, www.keyfree.co.
Keyfree RF manual Ver. 2.1 We sincerely appreciate your purchasing our Digital card key system. Our systems have been designed and tested to be compatible with the earliest to latest vehicles available throughout the world. Our primary goal is to provide a reliable and stable product. Our secondary goal is to ensure that our systems are easy to install. Our final goal is to provide features that would benefit the user and installer. We are confident that our products will meet and exceed your expectations.
Keyfree RF manual Ver. 2.1 Buttons description D: Display the menu or select the function menu. E: Entry the setup menu or to confirm the selected features. Display Menu Available standby menu (Select this function with D button) Display TEL1, TEL2, TEL3 SCAN Description Display in the absence of contacts by telephone number Scan type standby mode: Scanning the LED from left to right.
Keyfree RF manual Ver. 2.1 Cdel: Delete the registration card 1. Press E button for 2 seconds (setting menu entry) 2. D button pressed, the menu changed. Select the “Cdel” and then press E button to confirm. 3. Input the pin code (Default PIN code: “0000”) 4. Select Cd1, Cd2, Cd3, Cd4, Cd5, Cd6, Cd7 with D button and then confirm with E button to delete. 5. Display the “donE” and completed. Tadd: Phone number registration 1. Press E button for 2 seconds (setting menu entry) 2.
Keyfree RF manual Ver. 2.1 FAQ Q1: When there is no touch response Answer: 1) Unplug connectors of poor behavior, reconnect it (At this time “Keyfree RF On” should be display) 2) Please verify that the card is registered. Unregistered cards will not work. 3) Please verify that the card can be registered. Available card occur 3 times the buzzer. 4) Main unit should be installed within 1cm from windshield. Please approach the main unit as close as possible.
Keyfree RF manual Ver. 2.1 INSTALLATION MANUAL Specifications 1) Contents • Main unit, Main Holder, Harness wire, manual, 1X registered RF card, 1X registered RF tag, Double sided tape 2) Specification • Supply Voltage DC 3.3 V (Negative car only) • 13.
Keyfree RF manual Ver. 2.1 Wire Installation Black: (-) System Ground Input This wire should be connected to a ground source. Please ensure that no paint or rust exists on the surface where the wire will be attached. Also, ensure that the wire is securely fastened to the ground source. Red: (+12V) System Power Input This wire should be connected to a constant +12V. Main Power should be connected to 1A fuse.
Keyfree RF manual Ver. 2.1 Unlk: Programming of Unlock Pulses (Default: 1) FbLk: Lock and Unlock signal feedback (Default: OFF) 1. Press E button for 2 seconds (setting menu entry) 2. D button pressed, the menu changed. Select the “Unlk” and press the E button to confirm. 3. Select the Un 1, Un 2, Un 3, Un 4, Un 5 with D button and press 2 seconds with E button to end. 4. Display the “donE” and complete. 1. Press E button for 2 seconds (setting menu entry) 2. D button pressed, the menu changed.
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution Any changes or modifications (including the antenna) made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.