User Manual

www.BISSELL.com
5
1
Insert screws in
back of unit.
Tighten by rotating
the screw clockwise
until tightened.
Place handle on
vacuum base and
press down firmly.
Assembly
The only tool you will need to assemble
your vacuum is a Phillips screwdriver.
Place extension wand clip on back
of unit, twist clockwise to lock in.
2
3
4
5
6
7
Line up tabs on hose end to vacuum base and
twist clockwise to lock in.
NOTE: The powerfoot will not suction properly unless the hose is firmly attached.
Wrap hose up and around the
hose wrap on the handle. Slide
end of hose into vacuum base.
Store
TurboBrush®
on front of
handle.
Store dusting
brush above hose
wrap in holder.