User Manual

Trbleshting
Problem Possible causes Remedies
Built-in heater
ready light
does not
illuminate
The heater switch is not turned
ON ( I )
Turn the heater switch ON ( I )
The power switch is not turned
ON ( I )
Both switches must be ON ( I ) to
activate the heater ready light
Reduced
spray or
no spray
Water tank may be empty
Fill heavy duty bladder with hot tap water
Tank may not be seated completely Turn power OFF (0). Remove and reseat tank
Pump may have lost prime. Turn power OFF (0) and then back ON
(I). Wait one minute, then depress trigger
DirtLifter®
PowerBrush
does not turn
The belt is off or broken
Turn power OFF ( O ) and unplug unit
from outlet. Follow instructions on page 15
The unit is in the upright position Brushes only rotate when unit is
reclined using the detent pedal
Circuit breaker on machine may
have tripped
Turn the machine OFF ( O ) and
unplug from outlet. Check to see if
foreign object is caught in brush roll.
Remove object. Plug machine in to
reset circuit breaker
Cleaner
not picking
up solution
ReadyTools dial may be at wrong
setting
Set ReadyTools dial to either FLOOR
CLEANING or TOOLS setting
Tank may not be seated properly Pick up both the 2-in-1 water and
formula tank and reseat it to fit snugly
on the unit
Tank may not be assembled properly Check to make sure the "lip" of the
nozzle is securely hooked into the
groove on bottom of Tank (see page 7)
Solution or 2-in-1 water tank
is empty
Check fluid levels in heavy
duty bladder
2-in-1 water tank has picked up
maximum dirty water and red float
door has closed.
Empty 2-in-1 water tank. Refill heavy
duty bladder with clean hot tap water
and 2X formula and replace.
Red float "door" in the tank may
have closed as a result of bumping
an object or moving machine back
and forth too quickly
Turn the machine OFF ( O ), allowing red
float door to release into the open posi-
tion. Turn unit back ON ( I ) to continue
cleaning. Be sure your forward and back-
ward strokes are done at a slower pace.
Red lint screen in tank is dirty Remove red lint screen, clean and replace.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
For any questions or concerns, BISSELL is happy to
be of service. Contact us directly at 1-800-237-7691.
Please do
not return
this product
t o t h e s t o r e .
www.BISSELL.com 800.237.7691
16
WARNING
To reduce the risk of electric shock, turn power switch
o and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.