User Guide

www.BISSELL.com
13
To replace Large Belt or Rollers, first remove small belt
(see first 3 steps above). Remove the only screw holding
Pivot Arm, gently pull off arm with attached Rods
To replace the
Small Belt, flip
Base Unit with the
Pod Release Pedal
on the bottom
Remove the end cap
first. Then, remove
the only screw
holding Pivot Arm,
gently pull off arm to
expose Roller ends
Remove screw to
Pivot Arm, replace
the Small Belt
and reassemble
the End Caps
Replace the Small
Belt before
reversing steps to
reassemble Pivot
Arm and End Cap
Screw 1
End
Cap
Screw 2
Pod
Release
Pedal
Screw 3
Pivot Arm
Small
Belt
Roller
Small
Belt
Washer
Pod Release Pedal
Small
Belt
Maintenance: Replacing Small Belt
Maintenance: Replacing Large Belts and Rollers
IMPORTANT: Do not lose
the small washers held by
a magnet at both ends of
the Brushroll.
Replace Large Belt or Brush Rollers,
as required, carefully reassembling
the Rollers and Pivot Arm with
attached rods and secure the Pivot
Arm with the screw
To replace Small
Belt, flip the Base
Unit to the side
with the Pod
Release Pedal on
the bottom
Using Phillips
screwdriver,
remove three
screws from
the End Cap
and set to side
1
1
2
2
3
3
4