AIRRAM Vacuum ___________ USER GUIDE 1984/2144 SERIES
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT: READ ALL INSTRUCTIONS BEFORE USE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE. Do not use in rain or leave outdoors while raining. WARNING: Basic safety precautions should always be observed when using an electrical appliance, including the following to reduce the risk of fire, electrical shock, or injury: Personal Safety: Electrical safety: • Store indoors in a dry place out of the reach of children. • Only use batteries and chargers supplied by BISSELL.
cleaning or maintaining the appliance. Battery safety: • This appliance includes Li-Ion batteries; do not incinerate batteries or expose to high temperatures, as they may explode. • Liquid ejected from the battery may cause irritation or burns. • In an emergency situation contact professional help immediately! • Leaks from the battery cells can occur under extreme conditions. Do not touch any liquid that leaks from the battery. If the liquid gets on the skin wash immediately with soap and water.
Thanks for buying a BISSELL vacuum! We love to clean and we’re excited to share one of our innovative products with you. We want to make sure your vacuum works as well in two years as it does today, so this guide has tips on using (pages 5-8), maintaining (pages 9-13), and if there is a problem, troubleshooting (page 14). In just a few simple assembly steps, you’ll be ready to vacuum.
Assembly “click” Attach the lower handle onto the head of the AirRam. Press the button at the top of the upper handle and slot it into the lower handle until it clicks. “click” “click” Insert the battery by sliding it down. It will click into place. To extend the upper handle, hold down the button on the left hand side and pull it up. It will click into place. www.BISSELL.
Operation Without pressing the power button, place your foot on the left side of the AirRam head and pull the handle back. Press the button with your foot to turn the AirRam on. 6 www.BISSELL.com The power button is located on the left hand side of the AirRam head.
Storing Your AirRam To stow the upper handle, simply press the button on the left hand side and push the handle down. The handle will now be fully retracted and the AirRam can be conveniently stored. www.BISSELL.
Battery Charging When the state of charge indicator starts to flash one green LED, recharge the battery. The battery can be charged whilst the product. To remove the battery, squeeze the latch underneath and pull upwards. 5 hours Plug the charger in and connect it to the battery. 8 www.BISSELL.com The battery can be charged from flat in 5 hours. The state of charge indicator will show 4 green lights when it is charged. It is OK to charge for 1 hour for a burst of cleaning.
Emptying the Dirt Bin Firmly hold the AirRam with one hand and pull the dirt bin handle and lift the dirt bin our of the AirRam. Release the latch with the green arrow, to pull open the bin lid. Hold the AirRam’s dirt bin over a waste basket and push the green lever towards the open lid to empty. Pull the green lever back towards the bottom of the dirt bin. Close the dirt bin lid and reinsert into the AirRam.
Cleaning the Filters Firmly hold the AirRam with one hand and pull the dirt bin handle and lift the dirt bin out of the AirRam. Pull the filter out of the dirt bin. Tap the dirt from the filter and tip any dirt from the filter housing. Wash the filter if necessary. Firmly hold the filter and with the other hand grasp the separator cap. Gently pull the filter and separator cap apart. (Gently twisting and pulling You may gently wash the filter under warm water. Do not use detergents or soaps.
Replacing the Filters Slide the filter onto the separator. Slide the filter back into the dirt bin. Removing and Cleaning the Brush Roll If the brush bar jams during use, the AirRam will stop and the LEDs will appear red. Before checking for a blockage, remove the battery. Rest the AirRam on its side and locate the brush roll release button. Press and hold the release button and pull out the brush roll. NOTE: The brush roll should be pulled first from the side near the release button. www.BISSELL.
The brush roll can now be removed, starting at the button end. Clean the brush roll as needed. “click” Re-insert the brush roll, starting by locating the end furthest away from the button. Then push the brush roll into the AirRam until it clicks into place. 12 www.BISSELL.com Replace the battery by sliding it down. It will click into place.
10 seconds If the brush roll jams during use, the AirRam will stop working and the LED’s will appear red. You will need to remove the battery first, and then remove the brush roll to clean it. The AirRam will not re-start until the red LED lights go out. It should take approximately 10 seconds for the red has been removed, cleaned, and the jam is cleared. www.BISSELL.
Product Care Your BISSELL AirRam doesn’t need much maintenance: keep the filters clean, keep the brush bar tangle-free and charge the battery. Wipe it with a dry cloth if it gets dirty, including under the bin. Never wash it with liquid, run it under a tap or use it without the filter. Trouble Shooting WARNING: electrical outlet before performing maintenance or troubleshooting checks.
Warranty This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mail as described below.
Register your product today! Registering is quick, easy and offers you benefits over the lifetime of your product. You’ll receive: BISSELL Rewards Points Automatically earn points for discounts and free shipping on future purchases. Faster Service Supplying your information now saves you time should you need to contact us with questions regarding your product. Product Support Reminders and Alerts We’ll contact you with any important product maintenance reminders and alerts.
