POWERGLIDE® LIFT-OFF® PET PLUS Vacuum ___________ USER GUIDE 2043 SERIES More of a video person? Look for this icon and go online for an instructional how-to video at www.BISSELL.
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM. Always connect to a polarized outlet (one slot is wider than the other). Unplug from outlet when not in use and before conducting maintenance. When using an electrical appliance, basic precautions should be observed, including the following: WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: » Do not leave vacuum cleaner when it is plugged in. Unplug from outlet when not in use and before servicing.
Thanks for buying a BISSELL vacuum! We love to clean and we’re excited to share one of our innovative products with you. We want to make sure your vacuum works as well as it does today for years to come, so this guide has tips on using (pages 6-7), maintaining (pages 7-9), and if there is a problem, troubleshooting (page 10). In just a few simple assembly steps, you’ll be ready to vacuum.
Getting to Know Your Vacuum 1 11 16 3 4 2 5 6 12 13 7 14 8 15 9 10 1. Handle 2. Lift-Off Canister Release Button 3. Dirt Tank Release Button 4. Carry Handle 5. Brush Roll Power Switch 6. Power Switch 7. Quick Release® Cord Wrap 8. Power Cord 9. Filter Cover (Pre-Motor and Post-Motor Filters are located under Filter Cover) Cord Release and Storage Twist Cord Release down to quickly remove cord 4 www.BISSELL.com 10. Brush Roll 11. Cord Clip 12.
Assembly WARNING Do not plug in your vacuum until you are familiar with all instructions and operating procedures. 2 1 Slide handle into vacuum base. Attach with the screw that is taped to the handle. 4 3 Push handle end into base of vacuum on opposite side. 6 Attach hose by lining the tabs on the cuff with the notches on the back of vacuum. Twist clockwise to lock hose into place. 5 Slide the Crevice Tool/ Extension Wand Holder down onto the middle of the back of base.
PowerBrush Switch WARNING Before using your vacuum, make sure that the dirt container is in locked position and that all filters, both pre and post-filters are in place. DO NOT operate your vacuum without these filters. 2 1 Brush Roll On/Off Switch Power On/Off Switch Turn vacuum on by pressing Power Switch on (I - ON and O - OFF). Press the Brush Roll switch to run the PowerBrush for carpet cleaning (brush roll is on when light on switch is illuminated).
Above Floor Cleaning 1 Clean stairs or furniture easily with the removable canister. Push the green button to remove and attach desired tool. 2 To get the most reach, attach both the extension wand and Combination Dusting/Crevice Tool. 4 3 Use the Pet TurboEraser® tool for best results on your stairs. Replace the canister back on vacuum by aligning the front with the base of vacuum, then lean canister back and lock into place.
Cleaning Inner Cyclone 1 With dirt container off vacuum base, push the empty tank button and twist counter-clockwise to remove the separator and pull down. 2 Tap separator against inside of trash bin and rinse with warm water if necessary. Be sure to let it completely dry before placing back in the dirt container. 3 Place separator back in, being sure to align each tab on either side of the top of separator with the notches inside the top of the dirt container.
Replace Belt & Brush 1 3 Unplug vacuum, turn over and unscrew 8 Silver Phillips head screws to remove bottom cover. Inspect brush roll by placing it on its end and spin. The brush roll should spin freely, multiple times by one flick. If it doesn’t, replace brush roll. 2 Pull roller straight out and slide belt off brush roll and motor gear. 4 Place belt back on brush roll. Inspect belt, replace if it appears damaged. 6 5 Pinch belt around brush roll & hook back around the silver motor gear.
Troubleshooting WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.
Warranty This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mail as described below.
Register your product today! Registering is quick, easy and offers you benefits over the lifetime of your product. You’ll receive: BISSELL Rewards Points Automatically earn points for discounts and free shipping on future purchases. Faster Service Supplying your information now saves you time should you need to contact us with questions regarding your product. Product Support Reminders and Alerts We’ll contact you with any important product maintenance reminders and alerts.
