User Manual

8 BISSELL.com

1. Turn OFF your machine.

Remove the Dirt Tank from the

hand vacuum by sliding the

latch on the front of the tank.

2. Grab the top of the tank

and pull up. This will activate a

wiping feature to remove debris

from the mesh filter screen.

3. Fully remove the separator

from the tank and tap the

mesh screen on the side of the

trash bin.

4. Dump dirt from the tank

into the trash bin.

5. Slide the separator back

into the tank, ensuring the

notch is seated into the tank

correctly.

6. Put the whole tank into

the hand vacuum by guiding

the notched out area on the

bottom of the tank onto the

hook on the hand vacuum.

Push into place.

Emptying the Dirt Tank

More of a video person? Go to BISSELL.com/support for additional how-to videos.

WARNING

» Before using your vacuum, make sure that the Dirt Tank is in locked position and that all ﬁlters, both pre and post-ﬁlters, are in

place. DO NOT operate your vacuum without these ﬁlters.

Removing the Brush Roll

Go to BISSELL.com/support for a full list of maintenance and troubleshooting support.

1. Turn the machine OFF and

press the Foot Release Button

to disconnect the Motorized

Floor Cleaning Foot from the

Extension Wand.

2. With a flathead screwdriver

or coin, twist the slot on the

side of the foot clockwise and

pull the Brush Roll out.

3. To replace, push the Brush

Roll back in the chamber and

twist counter-clockwise with a

tool or coin to lock in place.