User Manual

BISSELL.com 9

Cleaning & Replacing the Filters

Go to BISSELL.com/support for tips on maintaining and replacing your vacuum filters.

1. To clean the pre-motor

filter, turn OFF machine and

remove Dirt Tank from the

hand vacuum.

2. Pull filter from the top of

the tank. Remove the filter

from the filter frame housing.

Tap the filter against the side

of a trash bin to remove dust

and debris.

3. To clean, rinse under warm

water and squeeze to remove

dirt. Lay out for 24 hours, until

completely dry. Make sure

to replace your filter into the

frame with the tag side down

(touching the frame) before

using your machine.

1. To clean your post-motor

filter, turn OFF machine and

press the latch on the back of

the hand vacuum.

2. Remove the post-motor

filter from the vacuum.

3. The pleated filter may NOT

be washed. If dust/debris

accumulates, gently tap the

filter on a trash bin. Place the

filter back into the vacuum and

replace the filter cover.

Pre-Motor Filters

For best cleaning performance, always clean your pre-motor filter after each use.

Post-Motor Filter

WARNING

» Do not use your vacuum until you are familiar with all instructions and operating procedures.

» Before using your vacuum, make sure that the Dirt Tank is in locked position and that all ﬁlters, both pre and post-ﬁlters, are in

place. DO NOT operate your vacuum without these ﬁlters.