Earn BISSELL Rewards! Register your product today! See details on back page USER'S GUIDE 4122 SERIES 2 Thank You 3 Safety Instructions 4 Product View 5 Assembly 5-7 Operations 8 Maintenance and Care 9 Troubleshooting 10 Replacement Parts 10 Accessories 11 Warranty 12 Product Registration 12 Consumer Care
Thanks for buying a BISSELL Vacuum Thanks for buying a BISSELL Zing canister vacuum .Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL Zing canister vacuum is well made, and we back it with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Care department, so, should you ever have a problem, you’ll receive fast, considerate assistance.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: Read all instructions before using your CANISTER VACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance. WARNING: To reduce the risk of fire, electric shock, or injury: ■ Do not leave cleaner when it is plugged in. ■ Unplug from outlet when not in use and before servicing.
Product view Air Flow Regulator Flex Hose Telescoping Extension Wand Swivel Hose Bag Change Indicator Tool Caddy Brush Switch Power Button Multi-Surface Floor Nozzle Post-Motor Filter Automatic Cord Rewind Button Variable Suction Power Control CAUTION: Do not plug in your vacuum Upholstery Tool 4 Combination Crevice Tool/ Dusting Brush www.bissell.com until you are familiar with all instructions and operating procedures. 800.237.
Assembly 1. Connect swivel hose by aligning the tabs WARNING: Plastic film can be dangerous. on the hose cuff with the suction inlet. Once the swivel hose is inserted, turn the hose cuff clockwise to lock into place. To avoid danger of suffocation, keep away from babies and children. 2. Connect telescoping extension wand to the handle end of the flex hose. 3. Connect the floor nozzle foot onto the telescoping extension wand. 4. Insert the combination crevice tool/ 3. 1.
Operations Power cord The power cord is located at the rear of the vacuum. Gently pull out the power cord, watching for the yellow line. Stop pulling the power cord once the yellow line is visible. There is also a red line, which indicates the end of the usable cord. Do not pull the power cord out beyond the red line. Power button Automatic Cord Turn the power ON or OFF by pressing lightly Rewind Button downward on the power button ( ).
Maintenance and care Bag change indicator The bag change indicator is located below the swivel hose. If the bag change indicator turns orange while you are vacuuming, the dust bag needs to be replaced. The dust bag may appear to be full or only partially full depending upon the type of debris picked up. Fine particles can block the airflow in the dust bag and reduce suction before the dust bag is full.
Maintenance and care Cleaning and replacing the pre-motor and post-motor filter Filters protect the motor from dirt and dust particles. Use only BISSELL replacement filters in your Zing Bagged canister vacuum. 1. Turn the power OFF ( ). Unplug the vacuum from electrical outlet. 2. Disconnect the flex hose by turning the hose cuff counterclockwise. 3. To locate the pre-motor filter, open the dust bag compartment by lifting up on the latch located underneath the carry handle.
Troubleshooting WARNING: To reduce the risk of electric shock, turn power OFF ( ) and disconnect plug from electrical outlet before performing maintenance or troubleshooting. Vacuum cleaner won’t run Possible causes Remedies 1. Vacuum cleaner is not plugged in 1. Check electrical plug 2. Power button is not pressed down 2. Press power button down 3. Thermal protector activated 3. Allow cleaner to cool for 30 minutes Vacuum cleaner won’t pick up or low suction Possible causes Remedies 1.
Replacement parts - BISSELL vacuum Item 1 2 3 Part No. 213-8425 203-8426 203-8427 1 2 Part Name Dust Bags (3-pack) Pre-Motor Filter Post-Motor Filter 3 Accessories Item 1 2 3 4 5 1 10 Part No. Part Name 2 3 203-8428 203-8418 203-7280 203-7273 203-8419 www.bissell.com Floor Nozzle Extension Wands with Tool Caddy Combination Crevice Tool/Dusting Brush Upholstery Tool Hose Assembly 4 5 800.237.
Warranty – BISSELL ZING ® Bagged Canister Vacuum This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mail as described below.
Don't forget to register your product! Registering is quick, easy and offers you benefits over the lifetime of your product. You’ll receive: BISSELL Rewards Points Automatically earn points for discounts and free shipping on future purchases. Faster Service Supplying your information now saves you time should you need to contact us with questions regarding your product. Product Support Reminders and Alerts We’ll contact you with any important product maintenance reminders and alerts.
