User Guide

www.BISSELL.com 800.237.7691
5
Your deep cleaner comes in two easy to
assemble components:
1. Upper handle
2. Portable spot cleaner/Base
The only tool you will need to assemble
your cleaner is a Phillips screwdriver.
1. Slide the upper handle onto the body of
the machine by guiding the 2 posts on the
body into the opening on the upper handle.
2. Firmly holding the upper handle in place,
screw 2 screws into the marked holes at an
upward angle above the
support handle.
3. At an upward angle, screw the remaining
2 screws into the marked outermost holes
under the support handle.
4. Wrap power cord around Quick Release
Cord Wrap.
5. Wrap flex hose around the hose wrap and
secure with hose secure latch.
6. Align the product as image 4 shows and
firmly push down the portable spot cleaner
until it is secured on both sides.
7. Check latches on both sides to confirm
it is secured.
To further check if the portable spot cleaner
is secure, plug in and turn on to verify that the
heat indicator light is illuminated. If the heat
indicator light does not illuminate, release the
pod and re-secure by pushing firmly until both
sides snap into place.
8. Snap attachment(s) into the back of unit.
NOTE: Portable spot cleaner must be fully
secure to operate in the upright mode.
Asmbly
WARNING
Do not plug in your deep cleaner until
you are familiar with all instructions and
operating procedures.
» Deep cleaning
carpeting regularly
can reduce dust
and allergens in
your home.
Tip
1.
1.
3.
7.
4.
2.
2.
IMPORTANT
ASSEMBLY INSTRUCTIONS
Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembly.
Slide the upper handle onto
the body of the machine by
guiding the 2 posts on the
body into the opening on
the upper handle.
Firmly holding the upper
handle in place, screw 2
screws into the marked
holes at an upward angle
above the support handle.
At an upward angle, screw
the remaining 2 screws into
the marked outermost holes
under the support handle.
IMPORTANT
ASSEMBLY INSTRUCTIONS
Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembly.
Slide the upper handle onto
the body of the machine by
guiding the 2 posts on the
body into the opening on
the upper handle.
Firmly holding the upper
handle in place, screw 2
screws into the marked
holes at an upward angle
above the support handle.
At an upward angle, screw
the remaining 2 screws into
the marked outermost holes
under the support handle.
IMPORTANT
ASSEMBLY INSTRUCTIONS
Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembly.
Slide the upper handle onto
the body of the machine by
guiding the 2 posts on the
body into the opening on
the upper handle.
Firmly holding the upper
handle in place, screw 2
screws into the marked
holes at an upward angle
above the support handle.
At an upward angle, screw
the remaining 2 screws into
the marked outermost holes
under the support handle.
Cord
side
Hose
side