User`s guide
Maintenance and care
Cleaning the pre-motor filter
The pre-motor filter protects the motor from dirt
and dust particles. Use only BISSELL replace-
ment filters in your PowerForce Multi Cyclonic.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. Remove the dirt container from the vacuum.
3. The pre-motor filter is located behind the
door labeled “FILTER” on the main body
of the vacuum. Open the door by
pushing up on the tab at the bottom of
the door and pulling out to remove.
4. Remove the filter tray by pulling up
on the tab of the tray. Remove the
pre-motor filter and set aside. Tap the
tray gently over a trash can to remove
any dirt or debris.
5. The pre-motor filter can be washed in
cold water with a mild detergent. Rinse
well and air dry thoroughly before
placing back into the tray.
6. Place the tray back into the vacuum
and replace the filter door by inserting
the tabs at the top of the door and
pushing down until it clicks into the
locked position.
Replacing the
Post-motor HEPA media filter*
The post-motor HEPA media filter* assists in
the filtration process to return clean air to the
room. Use only BISSELL replacement filters in
your PowerForce Multi Cyclonic.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. The post-motor filter is located behind
the door labeled “FILTER” on the rear of
the vacuum. Open the door by pushing
down on the tab of the door and pulling
out to remove.
3. Remove the post-motor HEPA media filter*
by grasping the handle on the filter and
pulling out to remove.
NOTICE:
This product is intended for household use
only and not for commercial or industrial
use. Vacuuming of dust from products like
plaster, concrete or ashes will damage the
motor and void the warranty.
Tip:
For maximum cleaning
performance, check the
filters often and clean or
replace if necessary.
WARNING:
Do not operate cleaner
with damp or wet filters or
without all filters in place.
Filter Tray
Pre-Motor Filter
3.
4.
Post-Motor HEPA
Media Filter*
2.
3.
*The filter media, not the vacuum as a whole, complies
with the IEST-RP-CC001.5 HEPA Standard
www.bissell.com
11