User`s guide

Maintenance and care
Replacing the media filter (cont)
4. Replace the post-motor HEPA media filter*
with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter*.
This filter is NOT washable and must
be replaced when it becomes dirty.
5. Replace the filter door by inserting the two
tabs at the bottom of the filter door. Then
push down on the tab on the door and
push it back into the vacuum. Release the
tab on the door to lock into place.
Wide Pet TurboBrush
™
Tool
(select models only)
The Wide Pet TurboBrush
™
Tool should
be checked regularly for clogs or debris
wrapping around the brush.
1. Unplug the vacuum from electrical outlet.
2. If a clog is present or debris is visible,
turn the collar on the neck of the
Wide Pet TurboBrush™ Tool counterclock-
wise to the unlocked position to remove the
faceplate and clear any obstructions.
3. To clean debris from the brush, remove the
brush from the drive belt and clean debris.
4. Reposition the drive belt on the brush.
Place the ends of the brush in the slots
on the sides. Reposition the faceplate
and turn the collar clockwise to the
locked position.
Thermal protector
An internal thremal protector has been
designed into your vacuum to protect it
from overheating. When the thermal
protector activates, the vacuum motor
will stop operating. If this happens:
1. Turn the vacuum OFF (O) and unplug
from electrical outlet.
2. Empty dirt container, check filters and
air passages for dirt accumulation.
3. The thermal protector automatically
resets after approximately 1 hour. If
the thermal protector does not reset,
call BISSELL Consumer Services.
*The filter media, not the vacuum
as a whole, complies with the
IEST-RP-CC001.5 HEPA Standard
WARNING:
Do not operate cleaner
with damp or wet filters or
without all filters in place.
www.bissell.com
12