User Guide

www.bissell.com 800.237.7691

Maintenance and care

Brush roll reset:

If larger debris becomes lodged in the foot of the

unit and the brush roll shuts off, turn the unit off

and remove the obstruction. Wait approximately

15 seconds for the motor to cool down before

turning back on. Brush will function again after

allowing time to cool down.

Brush roll belt replacement:

If the brush roll belt should break, call

1-800-237-7691 or visit WWW.BISSELL.COM

to purchase replacement belt.

Replacement instructions:

Turn power OFF (O). Remove foot

assembly from unit and turn over to access

the brush roll belt.

2. Remove three Phillips head screws to

remove the belt cover.

3. Locate broken belt.

4. Replace belt.

5. Place brush roll back into foot of unit.

6. Replace the belt cover and secure with

three screws.

7. Attach foot assembly on unit.

Disposal of batteries

If your Lift-Off Floors & More stick vacuum

is to be disposed of, the batteries should be

removed and disposed of properly.

1. IMPORTANT: Unplug Charger.

2. Remove hand vac from unit and remove

dirt cup from handle.

3. Remove (5) Phillips head screws on the

handle and cover.

WARNING:

This product contains Nickel Metal Hydride (NiMH) rechargeable

batteries. According to Federal and State regulations, removal

and proper disposal of NiMH batteries is required. For removal

of the batteries in your Lift-Off Floor & More stick vacuum see

instructions below.

Brush roll and brush roll belt maintenance continued

5 screws