User`s guide

Operations
6
Special Features
Removable water tank
The water tank is located on the back of
the Steam & Sweep. It can be refilled with
water any time during use. Distilled or
demineralized water is recommended in
place of tap water.
Do not use chemicals with your
Steam & Sweep.
Water purification system
This filter removes minerals and other
impurities from tap water, preventing water
deposits from damaging your Steam &
Sweep. It should be replaced when the
bright green grains turn blue. To maximize
performance of the filter, distilled water
should be used.
Ready light
The ready light will glow when water has
been converted to steam and the Steam &
Sweep is ready to use.
Steam on demand trigger
Press to release steam.
Maneuverable swivel head
Allows you to pick up dust and small
debris while steam cleaning your floor.
The maneuverable swivel head gets into
tight spaces and under cabinets.
Washable mop pads
Reusable microfiber mop pad is machine
washable and safe for all hard floor surfaces.
Getting ready
1. The mop pad may have already come
attached to the swivel head. If not, attach mop
pad to swivel head using the Velcro strips.
2. Fill the water tank.
A. Remove the tank by lifting straight up and
away from the unit.
B. Unscrew the cap at the bottom of
the water tank and remove the insert
assembly.
C. Fill the water tank with water. For best
results, water should be at room t
emperature.
Tip:
To prevent damage to the
machine, do not attempt to use
your Steam & Sweep without
water in the tank.
2A.
2B.
www.bissell.com