User Guide

11
www.bissell.com 800.237.7691
Replace drive belt
Use only BISSELL Style 10 Replacement Belts
(#32074) in your BISSELL PowerForce Bagless.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum
cleaner (Steps 1-4 of Check rotating floor brush
and drive belt), grasp old drive belt and remove
from motor pulley. Discard old drive belt.
3. Place new drive belt over motor pulley and
stretch other end over rotating floor brush in
the space between the bristles.
4. Place ends of rotating floor brush down into
slots on sides as shown.
5. Turn rotating floor brush by hand several times
in direction of motor pulley. If properly installed,
drive belt will center itself on rotating brush.
6. Reposition brush cover and four screws. Make
sure end of brush cover is snapped into place.
Maintenance and care
Press here
Brush
Cover
ug110_4018_6582_1107.indd 11ug110_4018_6582_1107.indd 11 12/19/07 9:59:11 AM12/19/07 9:59:11 AM