User Guide

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Maintenance and care
12
3. The dirt cup foam filter is located
between the bottom of the dirt cup and
the HEPA media filter. Once the HEPA
media filter has been removed, the
foam filter can then be removed and
cleaned or replaced as needed. To
clean the foam filter, wash with warm
water and a mild detergent. Be sure to
air dry completely before replacing this
filter back in the dirt cup.
4. To re-install the filters in the dirt cup,
turn dirt cup upside down and replace
the foam filter. Then replace the HEPA
media filter by inserting the tabs on the
back of the filter into the slots on the
bottom of the dirt cup and snap the filter
back into place.
Clearing clogs from the dirt cup
1. To clear clogs from the dirt cup, remove
the top cover and set aside.
2. Empty the dirt into a garbage container.
3. Reach down into the dirt cup cyclone
chamber to clear any dirt or debris from
the cyclone and empty into a garbage
container.
4. Remove the dirt cup, HEPA media filter
and foam filters and set aside.
5. Remove any dirt or debris from the
cyclone chamber opening.
6. If the holes in the cyclone appear to be
clogged, place the cyclone chamber
opening underneath running water and
allow water to run through the holes in
the cyclone to clear any clogs. Be sure
to allow the entire dirt cup assembly to
dry completely before replacing the dirt
cup, HEPA media filter and foam filters.
3.
4.
3.
5.
Cyclone
Chamber
Opening
Replacing dirt cup HEPA media filter & cleaning the foam filter