User Guide

5
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Assembly
Special features
Assembling your new BISSELL Flip-It is a simple
2 Step Process:
NOTE: Remove clean tank from unit first.
1. Insert the handle into the top of the unit,
making sure the spray trigger is on the Wet
Vacuum side. Make sure the screw opening
in the handle is aligned with the hole in the
housing of the unit.
2. Insert screw; gently screw in until tight with
the body of the unit.
Included with the purchase of your Flip-It are the
following Specialized Cleaning Accessories…
The Flip-It was designed to give the user the
ability to easily change between the Gentle
Clean™ Brushes and Pads.
Gentle Clean™ Brush
Recommended for use on hard floor surfaces
such as tile, vinyl, or surfaces that have grout or
crevices where dirt and grime collect.
Gentle Clean™ Pad
Intended for use on more delicate surfaces such
as sealed hardwood, laminates or vinyl.
Pleated filter
Located in the lid of the dirty tank should be
cleaned periodically.
Built-in heater
(On 7340 Flip-It Select Models only).
To use the Flip-It select's built-in heater, push
the power switch down. The heat indicator light
will come on. Within 25-30 seconds, the flow of
water and solution will be 25°F warmer.
1. 2.
WARNING:
To reduce the risk of
fire, use only BISSELL
2X Hard and Wood
Floor Cleaning Solutions
in your Flip-It. Use of
cleaning formulas
which contain lemon
or pine oil may damage
this appliance and void
the warranty. Chemical
spot cleaners or solvent
based soil removers
should not be used.
These products may
react with the plastic
materials used in your
Flip-It causing cracking
or pitting.
Dry Vacuum and
Wet Cleaning
Wet Cleaning using
Built-In Heater
Off