User Guide

Operation
7
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Wet cleaning /vacuuming
1. To begin Wet Cleaning, simply pull the Spray
Trigger. Water and Formula will be dispensed
through the Gentle Clean™ Brush or Pad.
2. On Flip-it Select Models, for heated
cleaning press the switch down to turn
on the Built-In Heater.
3. To maximize the area to be cleaned, it is
recommended that the Spray Trigger
is squeezed on the forward stroke and
released on the reverse stroke.
4. This will dispense water and formula going
forward and on the pull back, the squeegee
will leave the floor essentially dry and ready
to walk on.
Dirty tank is full
1. While Wet Cleaning, you will see dirty water
collected in the Dirty Tank. When the Tank is
full, the white Float in the Dirty Tank will rise
to the top, making a noticeable sound to let
you know it is time to empty the Dirty Tank.
Suction will stop when tank is full of water.
Dry Vacuum and
Wet Cleaning
Wet Cleaning using
Built-In Heater
Off
Tip:
To make sure water and formula are
flowing, squeeze the Spray Trigger
without the Gentle Clean™ Brush or
Pad Inserted. You should see a light
stream of water and formula dispensed
onto the floor.
CAUTION:
Do not over wet the floor. Apply
solution by depressing the
trigger on the forward stroke
only and release the trigger
on the rearward stroke. Over
wetting the floor surface may
cause delamination of certain
laminated flooring materials.