User Guide

8
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Emptying the dirty tank
1. Remove the Dirty Tank Lid. Then dump the
dirty water and debris into the sink, toilet,
laundry tub or outside. Rinse the tank out
with warm water and replace it in the unit.
Cleaning the filter
1. While the Dirty Tank is out of the unit,
remove the Pleated Filter from the top of the
tank. Remove dirt and debris from the pleats
by gently tapping the filter over the waste-
basket or outside.
2. The Pleated Filter can also be rinsed under
water to clean.
NOTE: If the Pleated Filter is rinsed with
warm water to clean, it is recommended
to leave it out of the unit to air dry before
placing it back in the unit.
Cleaning the Gentle Clean™ brush or pad
1. Gentle Clean™Brush
Remove the Brush from the unit and rinse
under warm water.
2. Gentle Clean™Pad
Remove the Gentle Clean™ Pad Plate from
the unit. Peel the pad from the Pad Plate and
toss in the wash!
Removing wet clean nozzle
1. Remove the Wet Clean Nozzle by pulling tab
on right and left side of nozzle. Rinse any
dirt and grime off the nozzle under warm tap
water.
2. To replace the Wet Clean Nozzle, insert the 4
tabs along the bottom of the Nozzle Window
and gently snap the Wet Cleaning Nozzle
back into place.
Storing the Flip-It
1. Your Flip-It can be stored Ready-to-Use, by
leaving water and formula in the unit. Be
sure to remove wet Gentle Clean™ Pad
before storing.
Maintenance and care
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
Tip:
If the Pleated Filter is rinsed
with warm water to clean,
it is recommended to leave
it out of the unit to air dry
before placing it back in
the unit.
1. 2.