User Guide

www.BISSELL.com
10
Set ReadyTools dial
Set ready tools dial to floor cleaning.
Power switch
1. Plug into a proper outlet and turn the power
and heater switches to the ON ( I ) position.
The switches are found on the back of the
handle. Allow 1 minute for the built-in heater
to warm-up before cleaning. The ProHeat
will be fully warmed and will provide optimal
performance after a minute of continuous
heated cleaning.
2. The heater ready light indicates when the
heater is ON ( I ).
NOTE: The built in heater heats the cleaning
solution for carpet and hard floor application
only. It does not heat solution sprayed through
the accessory tools.
Cleaning strokes
1. While pressing the trigger, make one slow
forward wet pass and another one back. Let
the built-in heater, formula, and DirtLifter
PowerBrush do the work for you. Caution: Do
not overwet. Take care not to run over loose
objects, edges of area rugs, or the cord. Stalling
the brush may result in premature belt failure.
2. Release the trigger and make one slow
forward and backward pass over the same area
to remove any residual dirty water, and aid in
drying. Repeat cleaning passes until solution
being pulled up appears clean. Continue passes
without pressing the trigger until you can’t see
any more water being pulled up.
NOTE: Both the SmartMix tank and the clean
water tank must have liquid in them in order for
the machine to spray. If one tank is empty the
machine will not apply cleaning solution
or water.
Operatis
SmartTemp
Light
2.
ReadyTools
Dial
1.